LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1211 (Folding Top System) >> Repair Instructions >> Roof Lift Off Panel Molding Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply tape to the edge of the roof panel to protect the panel.
  2. Remove the molding by placing a block of wood against the molding and tapping the block of wood with a hammer.
    Fig 1: Removing Molding By Placing Block Of Wood Against Molding
    G01451563Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals