LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1211 (Folding Top System) >> Repair Instructions >> Roof Lift Off Panel Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the locator on the molding to the corresponding locator on the edge of the roof panel.
  2. Install the molding by lightly tapping with a rubber mallet until fully seated.
  3. Remove the protective tape from the roof panel.
    Fig 1: Installing Molding By Lightly Tapping With Rubber Mallet Until Fully Seated
    G01451564Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals