LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1211 (Folding Top System) >> Repair Instructions >> Folding Top Roof Bow Replacement (Number 4 Bow) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the #4 bow to the main control link bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the #4 bow screws to the main control link bracket.

    Tighten 

    Tighten the screws to 13 N.m (10 lb ft).

  3. Position the top right side up and in a fully raised position.
  4. Staple the stay pad to the #4 bow.
  5. Install the headliner screws to the #4 bow.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

    Fig 1: #4 Bow To Main Control Link Bracket
    G01451449Courtesy of GENERAL MOTORS CORP.
  6. Turn the top over.
  7. Install the rear window support elastic strap screws to the #4 bow.

    Tighten 

    Tighten the screws to 2 N.m 18 lb in).

  8. Install the headliner elastic strap screws to the #5 bow

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  9. Install the headliner screws to the rear side rails.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  10. Install the glare cover end screws to the #5 bow.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  11. Before stapling the top cover to the #5 bow, Refer to FOLDING TOP COVER TENSION ADJUSTMENT - REAR .
  12. Install the folding top. Refer to FOLDING TOP REPLACEMENT .
  13. Reposition the folding top to the original position.
    Fig 2: Rear Window Support Elastic Strap Screws To #4 Bow
    G01451450Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals