LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1209 (Body Front End) >> Repair Instructions >> Wheelhouse Filler Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the filler panel over the wheelhouse panel and behind the fender wheel opening flange.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolts attaching the filler panel to the wheelhouse panel.

    Tighten 

    Tighten the filler panel to the wheelhouse bolts to 10 N.m (89 lb in).

    Fig 1: Installing Bolts Attaching Filler Panel To Wheelhouse Panel
    G01451037Courtesy of GENERAL MOTORS CORP.
  3. Install the bolts attaching the fender wheel opening to the filler panel.

    Tighten 

    Tighten the fender wheel opening to the filler panel bolts to 2 N.m (18 lb in).

    Fig 2: Installing Bolts Attaching Fender Wheel Opening To Filler Panel
    G01451038Courtesy of GENERAL MOTORS CORP.
  4. Install the bolts attaching the filler panel to the frame rail bolts.

    Tighten 

    Tighten the filler panel to the frame rail bolts to 2 N.m (18 lb in).

    Fig 3: Installing Bolts Attaching Filler Panel To Frame Rail Bolts
    G01451039Courtesy of GENERAL MOTORS CORP.
  5. Install the filler panel to the lower fender flange bolt.

    Tighten 

    Tighten the filler panel to the lower fender flange bolt to 2 N.m (18 lb in).

  6. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  7. Lower the vehicle.
    Fig 4: Installing Filler Panel To Lower Fender Flange Bolt
    G01451040Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals