LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1209 (Body Front End) >> Repair Instructions >> Seal Replacement - Fender to Hood >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the protective backing from the new seal.
  2. Align the seal to the fender vertical flange.
  3. Press the seal along its full length to secure the seal to the fender.
    Fig 1: Installing Seal To Fender Vertical Flange
    G01451031Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals