Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Insert the key into the lock cylinder.
Insert the lock cylinder into the passenger compartment door handle.
Align the lock cylinder in the same position used for removal, then push to seat fully.
Turn the key 1/4 turn counterclockwise to secure the lock cylinder retainer.
Turn the key an additional 1/4 turn counterclockwise and remove.
Inspect the operation of the lock cylinder.
The lock cylinder should only allow a 1/4 turn and should be securely retained in the door handle.

Fig 1: Inserting Lock Cylinder Into Passenger Compartment Door Handle
Courtesy of GENERAL MOTORS CORP.
Install the door handle to the passenger compartment.
Install the passenger compartment door handle retaining screws.
Close the passenger compartment door.

Fig 2: Installing Door Handle To Passenger Compartment
Courtesy of GENERAL MOTORS CORP.