LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1202 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Defroster Grille Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release and lift the windshield defroster grille from the I/P upper trim pad.
    1. Insert two small flat bladed screwdrivers, or other suitable tools, close to each other between the rear edge of the defroster grille and the upper trim pad near one corner of the grille.
    2. Begin to CAREFULLY pry the grille up from the trim pad.
    3. Work the screwdrivers gradually to the other corner of the grille while continuing to CAREFULLY pry the grille up.
  2. Lift the grille to access the DRL sensor and the sunload sensor, if equipped.
  3. Rotate to release the DRL sensor from the grille, if equipped.
  4. Rotate to release the sunload sensor from the grille, if equipped.
    Fig 1: Releasing DRL Sensor From Grille
    G01453894Courtesy of GENERAL MOTORS CORP.
    Fig 2: Releasing Sunload Sensor From Grille
    G01453895Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals