Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The power antenna is serviced as a complete unit only, however an antenna (mast) which has been bent or broken can be replaced, rather than replacing the complete power antenna.

Using the socket (1) provided with the antenna (mast) service kit, remove the antenna mast nut (2).

Fig 1: Removing Antenna Mast Nut Using Socket Provided With Antenna Service Kit
Courtesy of GENERAL MOTORS CORP.
Turn the ignition to the ACC or ON position.
Turn the radio ON to raise the power antenna.
Important:
- Prior to complete removal, note the orientation of the serrated side of the antenna mast plastic cable (5).
- The antenna mast plastic cable (5) will likely coil back once removed, take precautions to avoid grease splatter on the vehicle.
Remove the antenna mast (4) with the contact spring (3).
If may be necessary to gently pull the mast up by hand to release and remove.
Turn the radio OFF.
Turn the ignition OFF.

Fig 2: Removing Antenna Mast With Contact Spring
Courtesy of GENERAL MOTORS CORP.