LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1197 (Lighting Systems) >> Repair Instructions >> Repeater Lamp Replacement (Europe Japan) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the front side repeater lamp to the fender.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the front side repeater lamp retaining nuts.

    Tighten 

    Tighten the front side repeater lamp retaining nuts to 2 N.m (18 lb in).

  3. Install the socket to the lamp assembly.
  4. Install the wheelhouse filler panel. Refer to WHEELHOUSE FILLER REPLACEMENT in Body Front End.
    Fig 1: Lamp Assembly Retaining Nuts
    G01453369Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals