LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1197 (Lighting Systems) >> Repair Instructions >> Position Lamp Replacement - Front (Europe Japan) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the front fascia lower closeout panel. Refer to CLOSE OUT PANEL - FRONT BUMPER FASCIA LOWER in Bumpers.
  3. Release the brake caliper cooling duct from the front fascia, and position aside.
    Fig 1: Releasing Brake Caliper Cooling Duct From Front Fascia
    G01453358Courtesy of GENERAL MOTORS CORP.
  4. Open the lamp access door on top of the front fascia closeout.
  5. Remove the front position lamp socket from the lamp assembly.
    Fig 2: Removing Front Position Lamp Socket From Lamp Assembly
    G01453359Courtesy of GENERAL MOTORS CORP.
  6. Remove the front position lamp retaining screw.
  7. Remove the front position lamp assembly.
    Fig 3: Front Position Lamp Retaining Screw
    G01453360Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals