Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Remove the clutch actuator cylinder. Refer to CLUTCH ACTUATOR CYLINDER REPLACEMENT .
Use a small drift or punch to remove the roll-pin retaining the hydraulic hose to the actuator cylinder.

Fig 1: Clutch Actuator Cylinder
Courtesy of GENERAL MOTORS CORP.
Remove the hydraulic hose from the actuator cylinder.
Drain off the excess fluid from the actuator cylinder into a container.

Fig 2: Removing Hydraulic Hose From Actuator Cylinder
Courtesy of GENERAL MOTORS CORP.