LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1194 (Automatic Transmission - 4L60-E/4L65-E (Service & Replacement)) >> Repair Instructions >> Pressure Regulator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the transmission oil pan and filter. Refer to AUTOMATIC TRANSMISSION FLUID/FILTER REPLACEMENT .
  3. Compress the reverse boost valve sleeve into the bore of the oil pump to release tension on the reverse boost valve retaining ring.
  4. Remove the reverse boost valve retaining ring, then slowly release tension on the reverse boost valve sleeve.
    Fig 1: Transmission Oil Pan & Filter
    G01972975Courtesy of GENERAL MOTORS CORP.
  5. Remove the reverse boost valve sleeve (5) and the reverse boost valve (4).
  6. Remove the pressure regulator isolator spring (3) and the pressure regulator valve spring (2).
  7. Remove the pressure regulator valve (1).
    Fig 2: Pressure Regulator Valve
    G01972976Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals