LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1188 (Engine Mechanical - 5.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement-Air Conditioning >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the accessory drive belt. Refer to DRIVE BELT REPLACEMENT-ACCESSORY  .
  2. Install a breaker bar with hex-head socket to the air conditioning (A/C) drive belt tensioner bolt.
  3. Rotate the A/C drive belt tensioner clockwise in order to relieve tension on the drive belt.
  4. Remove the A/C drive belt from the pulleys.
  5. Slowly release tension on the A/C drive belt tensioner.
  6. Remove the breaker bar and socket from the A/C drive belt tensioner bolt.
  7. Clean and inspect the drive belt surfaces of the pulleys.
    Fig 1: Removing Air Conditioning Drive Belt
    G01970355Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals