LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1188 (Engine Mechanical - 5.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Replacement-Accessory >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the accessory drive belt idler pulley bolt until snug.
    Fig 1: Installing Accessory Drive Belt Idler Pulley
    G01970358Courtesy of GENERAL MOTORS CORP.

    Important:  Ensure that the idler pulley and dust shield are fully seated against the shoulder on the bracket before tightening the bolt.

  2. Install the accessory drive belt. Refer to DRIVE BELT REPLACEMENT-ACCESSORY  .
    NOTE: Refer to FASTENER NOTICE .
  3. Tighten the accessory drive belt idler pulley bolt.

    Tighten 

    Tighten the accessory drive belt idler pulley bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals