Clutch Pilot Bearing Removal

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 43276 Clutch Pilot Bearing Remover

NOTE: When using the J 43276 Clutch Pilot Bearing Remover always secure the J 43276-1 Clutch Pilot Bearing Remover tool body using a wrench. Do not allow the J 43276-1 tool body to rotate. Failing to do so will cause damage to the J 43276-1 tool body.

Remove the clutch pilot bearing using the J 43276 .

Fig 1: Removing Clutch Pilot Bearing
Courtesy of GENERAL MOTORS CORP.
1. 1.1. Install the J 43276-1 into the clutch pilot bearing.
2. 1.2. Using a wrench, secure the J 43276-1.
3. 1.3. Insert the J 43276-2 into the J 43276-1.
4. 1.4. Rotate the J 43276-2 clockwise into the J 43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
5. 1.5. Rotate the J 43276-2 counterclockwise to remove the J 43276-2 from the J 43276-1.
6. 1.6. Remove the J 43276-1 from the tool body.
Discard the pilot bearing.

Fig 2: View Of Clutch Pilot Bearing
Courtesy of GENERAL MOTORS CORP.