LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Engine Controls - Removal & Installation, Overhaul) >> Ignition Systems >> Spark Plugs >> Removal (3.1L)

Removal (3.1L)

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix, 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn OFF the ignition. To remove spark plugs from left cylinder bank (front cylinder head), remove the spark plug wires from spark plugs. Remove spark plugs from engine. To remove spark plugs from the right cylinder bank (rear cylinder head), remove the throttle body air inlet duct.
    2. NOTE: Engine must be rotated for service access.
  2. Remove wiper motor cover assembly. See appropriate WIPER/WASHER SYSTEMS article in ACCESSORIES & EQUIPMENT. Set the park brake. Shift the transaxle into Neutral. Remove the engine mount strut bolts. See Fig 1. Swing the engine mount struts aside. Install the Engine Tilter Strap (J-41131) to the engine. See Fig 2.
  3. Pull on the engine in order to rotate the engine forward. Tighten the engine tilter strap. Remove the spark plug wires from the spark plugs. Remove the spark plugs from the engine.
Fig 1: Removing Left Engine Mount Strut Bolt (3.1L - Right Is Similar)
G00114740Courtesy of GENERAL MOTORS CORP.
Fig 2: Installing Engine Tilter Strap (3.1L)
G00114739Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals