LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Engine Controls - Removal & Installation, Overhaul) >> Fuel Systems >> Fuel Sender Access Panel >> Installation

Fuel Sender Access Panel: Installation

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix, 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel sender access panel. Install the fuel sender access panel nuts. Tighten the nuts to specification. See TORQUE SPECIFICATIONS . Install the rear compartment trim panel to the rear compartment. See Fig 2.
  2. Unfold the trim panel sides and rear sections and press them into place. Install the spare tire. Install the spare tire cover in the rear compartment. Position the communication interface module and the bracket in the rear compartment. See Fig 1. Install the communications interface module bracket nuts. Tighten the bracket nuts to specification.
  3. Connect the GPS antenna cable by pushing in on the metal sleeve. Connect the two lower connectors to the module. Connect the cellular antenna by pressing in on the square plastic housing. Install the rear compartment mat in the rear compartment. Install the retainers by the rear compartment lock striker. Replace the lower rear compartment convenience net retainers. Install the rear compartment convenience net. Close the rear compartment.
Fig 1: Removing/Installing Communication Interface Module (Century, Grand Prix & Regal)
G00114776Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing Rear Compartment Trim Panel (Century, Grand Prix & Regal)
G00114777Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing/Installing Fuel Sender Access Panel (Century, Grand Prix & Regal)
G00114778Courtesy of GENERAL MOTORS CORP.


  1. Install the fuel sender access panel. Install the fuel sender access panel nuts. Tighten the nuts to specification. See TORQUE SPECIFICATIONS . Install the rear compartment trim panel to the installed position. Press the trim over the rear shock tower studs. Install the push-in retainers to the trim panel
  2. Install the spare tire cover to the rear compartment. Install the rear seat cushion and the rear seat back. Position the communication interface module and the bracket in the rear compartment. Connect the GPS antenna cable by pushing in on the metal sleeve. Connect the two lower connectors to the module.
  3. Connect the cellular antenna by pressing in on the square plastic housing. Install the nuts to the interface module bracket. Tighten the nuts to specification. Install the plastic cover on the communication interface module. Install the convenience net and retainers, if equipped. Install the tail lamp retainers. Install the sill plate. Close the rear compartment.
Fig 1: Removing/Installing Rear Compartment Seal Plate (Impala & Monte Carlo)
G00158355Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing Rear Compartment Trim Panel (Impala & Monte Carlo)
G00158356Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals