LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Engine Controls - Removal & Installation, Overhaul) >> Emission Systems & Sub-Systems >> EGR Valve Pipe >> Installation

EGR Valve Pipe: Installation

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix, 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EGR valve inlet pipe assembly. Install the mounting bolt and the stud to the EGR valve inlet pipe bracket. Tighten the bolt and stud to specification. See TORQUE SPECIFICATIONS .
  2. Install the EGR valve inlet pipe bolt to the exhaust manifold. Tighten the bolt to specification. Install EGR valve outlet pipe. See REMOVAL & INSTALLATION (3.8L - OUTLET PIPE) .
  3. If applicable, install the AIR pump outlet pipe. See SECONDARY AIR INJECTION PUMP OUTLET PIPE/HOSE . Install the EGR valve. See EGR VALVE .
Fig 1: Removing/Installing EGR Valve Inlet Pipe (3.8L)
G00158345Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals