LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Engine Controls - Removal & Installation, Overhaul) >> Air Induction Systems >> Boost Control Solenoid >> Removal & Installation (3.8L - VIN 1)

Removal & Installation (3.8L - VIN 1)

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix, 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Remove fuel injector sight shield (upper engine cover) from engine. Disconnect the boost source and signal hoses from the boost control solenoid. See Fig 1. Disconnect the boost control solenoid electrical connector. Remove the boost control solenoid retaining nut. Remove the boost control solenoid. To install, reverse removal procedure.

Fig 1: Locating Boost Control Solenoid & Bypass Valve Actuator (3.8L - VIN 1)
G00158342Courtesy of GENERAL MOTORS CORP.