Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Install the upper trim cover.

Fig 1: Installing Upper Trim Cover
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .
Secure the upper trim cover (1) with 2 TORX® head screws (2).
Tighten

Tighten the screws to 1.4 N.m (12 lb in).
Perform the following steps to install the lower trim cover:
1. 3.1. Verify that the slots on the lower trim cover engage with the tabs on the upper trim cover.
2. 3.2. Tilt the lower trim cover up and snap the trim covers together.
  
  Fig 2: Installing Lower Trim Cover
  Courtesy of GENERAL MOTORS CORP.
Install the 2 TORX® head screw (1) to the lower trim cover (2).
Tighten

Tighten the screws to 4 N.m (35 lb in).

Fig 3: Installing TORX® Head Screws To Lower Trim Cover
Courtesy of GENERAL MOTORS CORP.
Install the driver knee bolster trim panel. Refer to TRIM PANEL REPLACEMENT - KNEE BOLSTER in Instrument Panel, Gages and Console.

Fig 4: Installing Driver Knee Bolster Trim Panel
Courtesy of GENERAL MOTORS CORP.
Install the tilt lever. Refer to TILT LEVER REPLACEMENT .
Install the steering wheel. Refer to STEERING WHEEL REPLACEMENT .
Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .