LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1175 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> O-Ring Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the new O-ring seal for any sign or cracks, cuts, or damage. Replace if necessary.
  2. Using a lint-free clean, dry cloth, carefully clean the sealing surfaces of the A/C refrigerant components.

    Important:  DO NOT allow any of the mineral base 525 viscosity refrigerant oil on the new O-ring seal to enter the refrigerant system.

  3. Lightly coat the new O-ring seal with mineral base 525 viscosity refrigerant oil.

    Important:  DO NOT reuse O-ring seals.

  4. Carefully slide the new O-ring seal onto the A/C refrigerant component.
  5. The O-ring seal must be fully seated.
  6. Assemble the A/C components.

    Refer to the appropriate repair procedure.

scientia non olet · About LEMON Manuals