Compressor Clutch Plate and Hub Assembly Removal (V7 - Direct Mount)

• J 33013-B  Hub and Drive Plate Remover/Installer
• J 33027-A  Clutch Hub Holding Tool
• J 41790  A/C Compressor Holding Fixture

Tools Required 

1. Remove the A/C compressor from the vehicle.
2. Clamp the A/C compressor holding fixture, J 41790  in a vise and attach the A/C compressor to the J 41790  .
   Fig 1: Attaching A/C Compressor To J 41790

   Courtesy of GENERAL MOTORS CORP.
3. Hold the clutch hub and drive plate assembly (2) in place using the J 33027-A  .
4. Remove the A/C compressor shaft nut with a 13 mm socket (1).
   Fig 2: Removing A/C Compressor Shaft Nut

   Courtesy of GENERAL MOTORS CORP.
5. Thread the J 33013-B  into the hub.
6. Remove the hub and drive plate assembly (1) by turning the center screw into the body of the J 33013-B  and against the A/C compressor shaft.
7. Remove the shaft key and retain for reassembly.

Fig 3: Removing Hub And Drive Plate Assembly

Courtesy of GENERAL MOTORS CORP.