LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1175 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Air Outlet Duct Replacement - Rear Floor, LH >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the floor air outlet rear duct - LH in the same position in which it was released (1/4 turn above the installed position).
    2. Fig 1: Installing Air Outlet Duct - Rear Floor, LH
    G01418733Courtesy of GENERAL MOTORS CORP.
  2. Insert and seat the duct into the HVAC module.
  3. Rotate the duct 1/4 turn counterclockwise to secure.
  4. Install the driver knee bolster trim panel. Refer to TRIM PANEL REPLACEMENT - KNEE BOLSTER in Instrument Panel, Gages and Console.
  5. Install the IP accessory trim plate. Refer to TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY in Instrument Panel, Gages and Console.
  6. Install the console. Refer to CONSOLE REPLACEMENT in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals