LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Engine Controls - Removal & Installation) >> Emission Systems & Sub-Systems >> EVAP Canister >> Installation

EVAP Canister: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install EVAP canister into EVAP canister bracket front tab and press rear of EVAP canister into the EVAP canister bracket rear tabs. See Fig 2.
  2. Reconnect EVAP vapor pipe and EVAP vent valve pipe to EVAP canister. See Figure. Reconnect EVAP purge pipe to EVAP canister. See Fig 1.
  3. Reinstall fuel tank shield (if equipped). See Figure. Tighten fuel tank shield bolts to specification. See TORQUE SPECIFICATIONS . Lower vehicle.
Fig 1: Removing/Installing EVAP Canister Purge Pipe
G00156227Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing EVAP Canister
G00156228Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals