LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Engine Controls - Removal & Installation) >> Emission Systems & Sub-Systems >> EVAP Canister Vent Valve >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Disconnect EVAP canister vent valve harness connector. EVAP canister vent valve is located near right rear corner of fuel tank. See Figure.
  2. Disconnect EVAP vent pipe from EVAP canister vent valve. See Fig 1. Bend tab on EVAP canister vent valve bracket and remove EVAP canister vent valve from EVAP canister vent valve bracket. To install, reverse removal procedure.
Fig 1: Removing/Installing EVAP Canister Vent Valve
G00156230Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals