LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1168 (Engine Controls - 6.0L - Alternative Fuels (Introduction)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Compressed Natural Gas (CNG) Flammability Caution in Cautions and Notices.
    CAUTION: Refer to Compressed Natural Gas (CNG) Fuel Pressure Relief Caution in Cautions and Notices.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
    2. CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical in the C/K Pickup Service Manual.
    3. Fig 1: View Of Fuel Tank And Fuel Tank Cover
    GM757009Courtesy of GENERAL MOTORS CORP.
  3. Remove the tank cover (2). Refer to Fuel Tank Cover Replacement .
    4. Fig 2: Identifying HPL Line Fittings
    GM763013Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the fuel tank pressure (FTP) sensor connector (1).
  5. Remove the FTP sensor (2) from the high pressure lock-off (HPL) solenoid.
scientia non olet · About LEMON Manuals