LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1168 (Engine Controls - 6.0L - Alternative Fuels (Introduction)) >> Repair Instructions >> Fuel Hoses/Pipes Replacement - Union to Low Pressure Lock-Off (LPL) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Low Pressure Lock-Off (LPL) Solenoid Components
    GM756969Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel line (1) into the vehicle.
  2. CAUTION: Refer to Compressed Natural Gas (CNG) O-Ring Caution in Cautions and Notices.
  3. Connect the fuel line (1) to the low pressure lock-off (LPL) solenoid fitting (2) using a new O-ring face seal. Lubricate the O-ring with petroleum jelly.

    Tighten:  Tighten the fuel line to 37 N.m (27 lb ft).

  4. Fig 2: Identifying Center Fuel Line and Low Pressure Lock-Off (LPL)
    GM757011Courtesy of GENERAL MOTORS CORP.
  5. Connect the center fuel line (5) to the LPL fuel line (2) using a new O-ring. Lubricate the O-ring face seal with petroleum jelly.

    Tighten:  Tighten the fuel line to 37 N.m (27 lb ft).

  6. CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  7. Install the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical in the C/K Pickup service manual.
  8. Start the vehicle and inspect for CNG fuel leaks at the serviced fitting using the J 45878  or an equivalent liquid leak detector. See Special Tools and Equipment .