LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1168 (Engine Controls - 6.0L - Alternative Fuels (Introduction)) >> Repair Instructions >> Fuel Hoses/Pipes Replacement - High Pressure Regulator (HPR) to Union >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying HPR Fuel Outlet Line
    GM757013Courtesy of GENERAL MOTORS CORP.
  1. Install the line (3) into the vehicle.
    2. CAUTION: Refer to Compressed Natural Gas (CNG) O-Ring Caution in Cautions and Notices.
  2. Connect the high pressure regulator (HPR) line (3) to the underbody line (2) using a new O-ring face seal. Lubricate the O-ring with petroleum jelly.

    Tighten:  Tighten the fuel line to 37 N.m (27 lb ft).

    3. Fig 2: Identifying HPR Fuel Lines
    GM757012Courtesy of GENERAL MOTORS CORP.
  3. Connect the fuel line (4) to the HPR fitting (3) using a new O-ring. Lubricate the O-ring face seal with petroleum jelly.

    Tighten:  Tighten the fuel line to 37 N.m (27 lb ft).

    4. CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  4. Install the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical in the C/K Pickup service manual.
  5. Start the vehicle and inspect for CNG fuel leaks at the serviced fitting using the J 45878  or an equivalent liquid leak detector. See Special Tools and Equipment .
    6. Fig 3: View Of Fuel Tank And Fuel Tank Cover
    GM757009Courtesy of GENERAL MOTORS CORP.
  6. Install the tank cover (2). Refer to Fuel Tank Cover Replacement .
scientia non olet · About LEMON Manuals