LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1168 (Engine Controls - 6.0L - Alternative Fuels (Introduction)) >> Repair Instructions >> Fill Line Replacement (Cab/Chassis) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Compressed Natural Gas (CNG) Flammability Caution in Cautions and Notices.
    CAUTION: Refer to Compressed Natural Gas (CNG) Fuel Pressure Relief Caution in Cautions and Notices.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
    2. CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical in the C/K Pickup service manual.
  3. Remove the truck body as required on ZW9 equipped vehicles in order to gain access to the CNG fuel tank.
    4. Fig 1: Viewing Fill Line At Fill Valve
    GM296366Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the fill line (3) at the fill valve (1).
    5. Fig 2: Locating HPL Fuel Lines
    GM1203083Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the fill line (1) at the high pressure lock-off (HPL) solenoid.
    6. Fig 3: Identifying Fuel Line Hold-Down Components
    GM1203079Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel line retaining clips (1).
  7. Remove the check valve mounting bolt (4).
  8. Remove the fill line assembly from the vehicle.
scientia non olet · About LEMON Manuals