Engine Flywheel Installation

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

EN 46106 Engine Flywheel Holding Tool
J 45059 Angle Meter

Place the engine flywheel in position on the crankshaft.
Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.

Fig 1: View Of Tool EN 46106

Courtesy of GENERAL MOTORS CORP.

Install the EN 46106 .

Fig 2: Identifying Engine Flywheel Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the remaining NEW engine flywheel bolts.
Tighten:
1. Tighten the NEW engine flywheel bolts to 30 N.m (22 lb ft).
2. Tighten the NEW engine flywheel bolts an additional 45 degrees using the J 45059 .