LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1154 (Engine Mechanical (Repair Instructions 3 Of 5) - 3.6L (Ly7)) >> Repair Instructions (Off-Vehicle Repair Instructions - Part 2) >> Piston and Connecting Rod Assemble >> Piston and Piston Pin Installation Procedure

Piston and Piston Pin Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Piston Pin
    GM1210818Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • The arrow located on top of the piston must point toward the front of the engine.
    • The connecting rod is non-directional and may be assembled/reassembled to the piston in either direction.
  1. Lubricate the piston pin bores in the piston and the connecting rod with GM prelube lubricant GM P/N 1052367 (Canadian P/N 992869) or equivalent.
  2. Assemble the piston and piston pin to the connecting rod. Properly orient the piston when reusing a marked connecting rod.
  3. Align the piston pin bore with the connecting rod pin bore.
  4. Slide the piston pin into the piston and the connecting rod.
    5. Fig 2: Identifying Piston Pin Retainers Removal Access Notch
    GM1210796Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: New piston pin retainers must be used. Never reuse the piston pin retainers.
  5. Install NEW piston pin retainers using the J 43654  . Align the J 43654  to the notch (1) in the piston.
  6. Ensure that the piston pin retainers are fully seated in their grooves.
  7. Repeat these procedures for the remaining pistons.
scientia non olet · About LEMON Manuals