LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1154 (Engine Mechanical (Repair Instructions 3 Of 5) - 3.6L (Ly7)) >> Repair Instructions (Off-Vehicle Repair Instructions - Part 2) >> Oil Pan Assemble

Oil Pan Assemble

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Suction Tube Seal & Oil Suction Tube
    GM1318091Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW oil suction tube seal onto the oil suction tube. DO NOT reuse the old oil suction tube seal.
    2. Fig 2: View Of Oil Suction Pipe Bolts
    GM1408412Courtesy of GENERAL MOTORS CORP.
  2. Install the oil suction pipe.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the oil suction pipe bolts.

    Tighten:  Tighten the oil suction pipe bolts to 10 N.m (89 lb in).

    4. Fig 3: Identifying Oil Pan Scraper & Bolts
    GM1408410Courtesy of GENERAL MOTORS CORP.
  4. Install the oil pan scraper.
  5. Install the oil pan scraper bolts.

    Tighten:  Tighten the oil pan scraper bolts to 10 N.m (89 lb in).

    6. Fig 4: Locating Oil Pan Drain Plug
    GM1408408Courtesy of GENERAL MOTORS CORP.
  6. Install the oil pan drain plug and NEW O-ring seal.

    Tighten:  Tighten the oil pan drain plug to 20 N.m (15 lb ft).

    7. Fig 5: View Of Oil Level/Condition Sensor
    GM1408406Courtesy of GENERAL MOTORS CORP.
  7. Install the oil level/condition sensor.

    Tighten:  Tighten the oil level/condition sensor to 20 N.m (15 lb ft).

scientia non olet · About LEMON Manuals