LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1154 (Engine Mechanical (Repair Instructions 3 Of 5) - 3.6L (Ly7)) >> Repair Instructions (Off-Vehicle Repair Instructions - Part 2) >> Intake Manifold Disassemble >> Upper Intake Manifold Disassemble Procedure

Upper Intake Manifold Disassemble Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Throttle Body Bolts
    GM1408449Courtesy of GENERAL MOTORS CORP.
  1. Remove the throttle body bolts.
  2. Remove the throttle body.
  3. Remove and discard the throttle body gasket.
    4. Fig 2: Identifying Barometric Pressure (BARO) Sensor Bolt
    GM1408451Courtesy of GENERAL MOTORS CORP.
  4. Remove the barometric pressure (BARO) sensor bolt.
  5. Remove the BARO sensor.
    6. Fig 3: View Of Communicator Valve Bolts
    GM1408453Courtesy of GENERAL MOTORS CORP.
  6. Remove the communicator valve bolts.
  7. Remove the communicator valve.
scientia non olet · About LEMON Manuals