LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1154 (Engine Mechanical (Repair Instructions 3 Of 5) - 3.6L (Ly7)) >> Repair Instructions (Off-Vehicle Repair Instructions - Part 2) >> Intake Manifold Assemble >> Lower Intake Manifold Assemble Procedure

Lower Intake Manifold Assemble Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Injector Rail & Bolts
    GM1408456Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel injector rail.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the fuel injector rail bolts.

    Tighten:  Tighten the fuel injector rail bolts to 10 N.m (89 lb in).

    3. Fig 2: View Of Fuel Injector Wiring Harness
    GM1408455Courtesy of GENERAL MOTORS CORP.
  3. Install the fuel injector wiring harness connector.
scientia non olet · About LEMON Manuals