LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1154 (Engine Mechanical (Repair Instructions 3 Of 5) - 3.6L (Ly7)) >> Repair Instructions (Off-Vehicle Repair Instructions - Part 2) >> Camshaft Cover Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Ignition Coil Seals With J 24254
    GM1211046Courtesy of GENERAL MOTORS CORP.
  1. Install the NEW ignition coil seals using the J 24254  .
    2. Fig 2: Identifying Camshaft Cover Gasket
    GM1211021Courtesy of GENERAL MOTORS CORP.
  2. Install the NEW camshaft cover gasket.
    3. Fig 3: Locating Camshaft Cover Bolts & Grommets
    GM1211016Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The camshaft cover bolt grommet must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.
  3. Install the NEW camshaft cover bolt grommets.
  4. Install the camshaft cover bolts.
scientia non olet · About LEMON Manuals