LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1152 (Engine Mechanical (Introduction) - 3.6L (Ly7)) >> Diagnostic Information and Procedures >> Engine Noise Under Load

Engine Noise Under Load

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Engine Noise Under Load

Cause Correction
Low oil pressure
Detonation or spark knock Verify the correct operation of the ignition controls. Refer to Detonation/Spark Knock in Engine Controls - 3.6L.
Loose torque converter bolts
  • Inspect the torque converter bolts and engine flywheel.
  • Repair as required.
Cracked engine flywheel
  • Inspect the engine flywheel and bolts.
  • Repair as required.
Excessive connecting rod bearing clearance Inspect the following components, and repair as required:
  • The connecting rod bearings
  • The connecting rods
  • The crankshaft
Excessive crankshaft bearing clearance Inspect the following components, and repair as required:
  • The crankshaft bearings
  • The crankshaft journals
  • The cylinder block crankshaft bearing bore