LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1151 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Receiver Dehydrator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. If replacing the receiver dehydrator, add the specified amount of PAG oil directly to the receiver dehydrator. Refer to Refrigerant System Capacities .
  2. Install new sealing washers to the receiver dehydrator.
    3. Fig 1: View Of Receiver Dehydrator Upper Bracket Bolt
    GM887653Courtesy of GENERAL MOTORS CORP.
  3. Connect the receiver dehydrator to the condenser. Refer to Sealing Washer Replacement .
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the receiver dehydrator lower mounting bolts.

    Tighten:  Tighten the bolts to 6 N.m (53 lb in).

  5. Install the receiver dehydrator upper bracket bolt.

    Tighten:  Tighten the bolt to 6 N.m (53 lb in).

  6. Install the condenser. Refer to Condenser Replacement .
  7. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  8. Leak test the fittings of the component using J 39400-A  .
scientia non olet · About LEMON Manuals