LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1151 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Outlet Replacement - Auxiliary Air - Floor Console (Aztek) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Center & Rear Ducts (Aztek)
    GM656425Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear section of the console trim panel. Lift up and towards the rear to release the clips.
  2. Disconnect the rear power supply electrical connector.
  3. Remove the rear duct screws.
  4. Remove the rear duct from the console.
  5. If you are replacing the center section of the console duct, perform the following procedure:
    1. Remove the center console. Refer to Console Replacement - Front Floor (Aztek) or Console Replacement - Front Floor (Rendezvous) in Instrument Panel, Gages, and Console.
    2. Rotate the console so that the bottom side is up.
    3. Remove the center duct screws.
    4. Remove the center console duct from the console.
scientia non olet · About LEMON Manuals