LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1151 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Outlet Replacement - Auxiliary Air - Floor Console (Aztek) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Center & Rear Ducts (Aztek)
    GM656425Courtesy of GENERAL MOTORS CORP.
  1. If you are replacing the center section of the console duct, perform the following procedure:
    1. Install the center console duct to the console.
      2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    2. Install the center console duct screws.

      Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

    3. Install the center console. Refer to Console Replacement - Front Floor (Aztek) or Console Replacement - Front Floor (Rendezvous) in Instrument Panel, Gages, and Console.
    2. IMPORTANT: Align the rear power supply harness away from the center mounting stud of the rear duct.
  2. Install the rear duct to the console.
  3. Install the rear duct screws.

    Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

  4. Connect the rear power supply electrical connector.
  5. Install the rear section of the console trim panel.
scientia non olet · About LEMON Manuals