Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disassembling/Reassembling A/C Line Fittings

Courtesy of GENERAL MOTORS CORP.

Disassemble the A/C refrigerant components. Refer to the appropriate repair procedure.
- For compression style fittings use a back up wrench on the fitting (2) and loosen the fitting nut (1).
- For banjo style fittings remove the bolt retaining the banjo type fitting.
Remove the O-ring seal from the A/C refrigerant component.
Inspect the O-ring seal for signs of damage.
Inspect the A/C refrigerant components for damage or burrs. Repair if necessary.
Discard the O-ring seal.