Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Install the heater outlet duct.
- Install the heater outlet duct screws.
Tighten: Tighten the screws to 0.9 N.m (8 lb in).
- Install the center floor air outlet. Refer to Air Outlet Replacement - Center Floor .
- Install the I/P compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
- Install the left I/P insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
- Install the right I/P insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
NOTE:
Refer to Fastener Notice in Cautions and Notices.