LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1150 (Transfer Case - STEYR) >> Repair Instructions >> Axle Shaft Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the right front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the right front wheel drive shaft. Refer to Wheel Drive Shaft Replacement - Front in Wheel Drive Shafts.
    4. Fig 1: Removing Axle Shaft Oil Seal
    GM640539Courtesy of GENERAL MOTORS CORP.
  4. Using the J 2619-O1  with the J 29794  and the J 23129  remove the axle shaft oil seal (1) from the transfer case. See Special Tools and Equipment .
scientia non olet · About LEMON Manuals