LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Rear Suspension - Old Style) >> Removal & Installation >> Wheel Stud (Semi-Floating Axle) >> Installation

Wheel Stud (Semi-Floating Axle): Installation

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2000 GMC Yukon, 2000 GMC Pickup, 2000 GMC Cab & Chassis, 2000 GMC C3500 HD, and 2000 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start the NEW stud into the axle flange hole by pressing firmly with your hand.
  2. Thread the lug nut on the stud with the flat side of the lug nut to the vehicle. See Figure .
  3. Tighten the lug nut in order to draw the stud into the rear of the flange.
  4. Thread the lug nut off the stud.
  5. Instal the brake drum. See 1998 DISC & DRUM -- TRUCKS -- EXCEPT TRACKER , 1999 DISC & DRUM -- TRUCKS -- EXCEPT TRACKER or 2000-01 DISC & DRUM -- TRUCKS -- EXCEPT TRACKER .
  6. Install the tire and wheel assembly. Tighten wheel lug nuts to specification. See TORQUE SPECIFICATIONS  .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals