LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Rear Suspension - Old Style) >> Removal & Installation >> Stabilizer Shaft >> Installation

Stabilizer Shaft: Installation

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2000 GMC Yukon, 2000 GMC Pickup, 2000 GMC Cab & Chassis, 2000 GMC C3500 HD, and 2000 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft (4) to the rear axle. See Figure .
  2. Install the insulators (13 and 16) and the clamps (12 and 17). See Figure .
  3. Install the bolts (15) to the clamps. Do not tighten bolts at this time. See Figure .
  4. Install the lower bolts through the stabilizer shaft ends (4), the stabilizer links (14 and 18), and the washers (9 and 19). See Figure .
  5. Install the nuts (8 and 20). Then tighten the clamp bolts and the stabilizer link nut. See Figure . See TORQUE SPECIFICATIONS  .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals