LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Rear Suspension - Old Style) >> Removal & Installation >> Stabilizer Shaft Link Bracket (C/K3 Models) >> Installation

Stabilizer Shaft Link Bracket (C/K3 Models): Installation

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2000 GMC Yukon, 2000 GMC Pickup, 2000 GMC Cab & Chassis, 2000 GMC C3500 HD, and 2000 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft insulators (6, 8, 10) and spacers (9). Do not tighten. See Figure .
  2. Install the link bolt (7) through the stabilizer shaft, the insulators (6, 8, 10) and the spacer (9). Do not tighten nuts at this time.
  3. Install the link bolt (7) through the frame and install the upper insulator (6). Do not tighten nuts at this time.
  4. Install the link nut (11). Tighten the link nut to specification. See Figure . See TORQUE SPECIFICATIONS  .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals