LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Rear Suspension - Old Style) >> Removal & Installation >> Stabilizer Shaft Link (All Models Except C/K3) >> Removal

Stabilizer Shaft Link (All Models Except C/K3): Removal

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2000 GMC Yukon, 2000 GMC Pickup, 2000 GMC Cab & Chassis, 2000 GMC C3500 HD, and 2000 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Support the vehicle suitably safety standards.
  2. Remove the following parts from the stabilizer links:
    • The upper nuts (8 and 21). See Figure .
    • The upper washers (9 and 22).
    • The upper bolts (3 and 11).
    • The lower nuts (8 and 20).
    • The lower washers (9 and 19).
    • The lower bolts (14 and 18).
  3. Remove the stabilizer links (10) to bracket (1 and 6).
scientia non olet · About LEMON Manuals