LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1147 (Drum Brake System) >> Repair Instructions >> Drum Brake Hardware Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Components
    GM695644Courtesy of GENERAL MOTORS CORP.
  1. Install the brake shoe hold-down pins, springs and retainers (4) to the brake shoes.
  2. Install the straight end of the adjuster spring (3) to the brake shoe.
  3. Install the adjuster spring hook end to the tab on the adjuster actuator (1).
  4. Install the return spring (7) to the brake shoes.
    5. Fig 2: View Of Brake Drum
    GM390075Courtesy of GENERAL MOTORS CORP.
  5. Install the brake drum. Refer to Brake Drum Replacement .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals