LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1147 (Drum Brake System) >> Repair Instructions >> Drum Brake Backing Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the backing plate.
    2. Fig 1: Identifying Wheel Bearing/Hub
    GM864720Courtesy of GENERAL MOTORS CORP.
  2. Install the wheel bearing/hub. Refer to Wheel Bearing/Hub Replacement - Rear (Front Wheel Drive/Drum) or Wheel Bearing/Hub Replacement - Rear (Disc and AWD) in Rear Suspension.
    3. Fig 2: View Of Brake Components
    GM695644Courtesy of GENERAL MOTORS CORP.
  3. Install the wheel cylinder. Refer to Wheel Cylinder Replacement .
  4. Install the park brake cable to the backing plate.
  5. Install the park brake cable (6) to the park brake actuator (5).
  6. Install the brake shoes. Refer to Brake Shoe Replacement .
  7. Adjust the brake shoes. Refer to Drum Brake Adjustment .
  8. Adjust the park brake cable. Refer to Park Brake Adjustment (Disc) or Park Brake Adjustment (Drum) .
  9. Install the brake drum. Refer to Brake Drum Replacement .
  10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals