LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1140 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Thermo Element Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Thermo Element Plate
    GM164816Courtesy of GENERAL MOTORS CORP.
  1. Use the J 34094-A  to set the middle thermo pin (123). See Special Tools and Equipment .
  2. Install the new thermo element plate (122).
  3. Install the pin and washer (120).
  4. Use the J 34094-A  to set the height of the pin and washer (120) furthest from the accumulator. See Special Tools and Equipment .
  5. Use the J 34094-A  to set the height of the second pin and washer (120). See Special Tools and Equipment .
    6. Fig 2: View Of Thermo Element & Plate
    GM164817Courtesy of GENERAL MOTORS CORP.
  6. Carefully install the thermo element (121) between the two pin and washers (120). The V in the thermo element (121) must contact the thermo element plate (122).
  7. Install the oil pan. Refer to Oil Pan Replacement .
scientia non olet · About LEMON Manuals