LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1140 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Forward Servo Replacement (M76 (AWD)) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Forward Servo Assembly
    GM164777Courtesy of GENERAL MOTORS CORP.
  1. Install the servo spring.
  2. Install the servo piston assembly.
  3. Install the forward servo cover O-ring.
  4. Install the forward servo cover.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the forward band servo cover bolts.

    Tighten:  Tighten the forward band servo cover bolts to 12 N.m (106 lb in).

  6. Install the transfer case. Refer to Transfer Case and/or Seal Replacement in Transfer Case - Steyr.
scientia non olet · About LEMON Manuals